|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | What is going on in magnesium alloys?显示文摘China has been developed into one of the most active regions in terms of both fundamental and applied research on magnesium(Mg) and its alloys in the world from a solid base laid by its prominent metallurgist and materials scientists over the past decades. Nowadays, a large number of young-generation researchers have been inspired by their predecessors and become the key participants in the fields of Mg alloys, which consequently led to the establishment of China Youth Scholar Society for Magnesium Alloys Research in 2015. Since then, the first two China Youth Scholars Symposiums on Mg Alloys Research had been held at Harbin(2015) and Chongqing(2016) China, respectively. A number of crucial research interests related to fundamental and applied Mg research were discussed at the conferences and summarized in this short perspective, aiming to boost far-reaching initiatives for development of new Mg-based materials to satisfy the requirements for a broad range of industrial employments. Herein, four main aspects are included as follows: i) Plastic deformation mechanism and strengthening strategy, ii) Design and development of new Mg-based materials, iii) Key service properties, and iv) New processing technologies. | X.J. Wang D.K. Xu R.Z. Wu X.B. Chen Q.M. Peng L. Jin Y.C. Xin Z.Q. Zhang Y. Liu X.H. Chen G. Chen K.K. Deng H.Y. Wang | 2018 | Journal of Materials Science & Technology2018，34，2： | 35 |
| 2 | Effects of icosahedral phase formation on the microstructure and mechanical improvement of Mg alloys:A review | D.K. Xu E.H. HanAuthor Vitae | 2012 | Progress in Natural Science:Materials International2012，22，5： | 20 |
| 3 | The clinical value of serum CEA, CA19-9, and CA242 in the diagnosis and prognosis of pancreatic cancer显示文摘 | X.G. Ni X.F. Bai Y.L. Mao Y.F. Shao J.X. Wu Y. Shan C.F. Wang J. Wang Y.T. Tian Q. Liu D.K. Xu P. Zhao | 2004 | European Journal of Surgical Oncology2004，，2： | 2 |
| 4 | Improved solution treatment for an as-rolled Al–Zn–Mg–Cu alloy. Part I. Characterisation of constituent particles and overheating显示文摘 | D.K. Xu P.A. Rometsch N. Birbilis | 2011 | Materials Science & Engineering A2011，，： | 2 |
| 5 | Mechanical properties of the icosahedral phase reinforced duplex Mg–Li alloy both at room and elevated temperatures显示文摘 | D.K. Xu T.T. Zu M. Yin Y.B. Xu E.H. Han | 2014 | Journal of Alloys and Compounds2014，，： | 1 |
| 6 | Effect of solution treatment on the corrosion behaviour of aluminium alloy AA7150: Optimisation for corrosion resistance显示文摘 | D.K. Xu N. Birbilis D. Lashansky P.A. Rometsch B.C. Muddle | 2010 | Corrosion Science2010，，1： | 1 |
| 7 | The strengthening effect of icosahedral phase on as-extruded Mg–Li alloys显示文摘 | D.K. Xu L. Liu Y.B. Xu E.H. Han | 2007 | Scripta Materialia2007，，3： | 1 |
| 8 | Effect of Y concentration on the microstructure and mechanical properties of as-cast Mg–Zn–Y–Zr alloys显示文摘 | D.K. Xu W.N. Tang L. Liu Y.B. Xu E.H. Han | 2006 | Journal of Alloys and Compounds2006，，1： | 1 |
| 9 | Buffeting analysis of long span bridges: a new algorithm显示文摘 | Y.L. Xu D.K. Sun J.M. Ko J.H. Lin | 1997 | Computers and Structures1997，，4： | 1 |
| 10 | Retinopathy in a Chinese population with type 2 diabetes: factors affecting the presence of this complication at diagnosis of diabetes显示文摘 | D.P. Liu L. Molyneaux E. Chua Y.Z. Wang C.R. Wu H. Jing L.N. Hu Y.J. Liu Z.R. Xu D.K. Yue | 2002 | Diabetes Research and Clinical Practice2002，，2： | 1 |
| 11 | The influence of element Y on the mechanical properties of the as-extruded Mg–Zn–Y–Zr alloys显示文摘 | D.K. Xu L. Liu Y.B. Xu E.H. Han | 2006 | Journal of Alloys and Compounds2006，，1： | 1 |
| 12 | The effect of pre-ageing temperature and retrogression heating rate on the strength and corrosion behaviour of AA7150显示文摘 | D.K. Xu N. Birbilis P.A. Rometsch | 2011 | Corrosion Science2011，，： | 1 |
| 13 | Fully coupled buffeting analysis of Tsing Ma suspension bridge显示文摘 | Y.L. Xu D.K. Sun J.M. Ko J.H. Lin | 2000 | Journal of Wind Engineering & Industrial Aerodynamics2000，，1： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员