|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Identification of New Resistance Loci Against Sheath Blight Disease in Rice Through Genome-Wide Association Study显示文摘Sheath blight(SB) caused by the soil borne pathogen Rhizoctonia solani is one of the most serious global rice diseases. Breeding resistant cultivar is the most economical and effective strategy to control the disease. However, no rice varieties are completely resistant to SB, and only a few reliable quantitative trait loci(QTLs) linked with SB resistance have been identified to date. In this study, we conducted a genome-wide association study(GWAS) of SB resistance using 299 varieties from the rice diversity panel 1(RDP1) that were genotyped using 44 000 high-density single nucleotide polymorphism(SNP) markers. Through artificial inoculation, we found that only 36.5% of the tested varieties displayed resistance or moderate resistance to SB. In particular, the aromatic and aus sub-populations displayed higher SB resistance than the tropical japonica(TRJ), indica and temperate japonica sub-populations. Seven varieties showed similar resistance levels to the resistant control YSBR1. GWAS identified at least 11 SNP loci significantly associated with SB resistance in the three independent trials, leading to the identification of two reliable QTLs, qSB-3 and qSB-6, on chromosomes 3 and 6. Using favorable alleles or haplotypes of significantly associated SNP loci, we estimated that both QTLs had obvious effects on reducing SB disease severity and can be used for enhancing SB resistance, especially in improving SB resistance of TRJ sub-population rice varieties. These results provided important information and genetic materials for developing SB resistant varieties through breeding. | CHEN Zongxiang FENG Zhiming KANG Houxiang ZHAO Jianhua CHEN Tianxiao LI Qianqian GONG Hongbing ZHANG Yafang CHEN Xijun PAN Xuebiao LIU Wende WANG Guoliang ZUO Shimin | 2019 | Rice science2019，26，1： | 3 |
| 2 | UV light-induced oxygen doping in graphitic carbon nitride with suppressed deep trapping for enhancement in CO_(2) photoreduction activity显示文摘While photoreduction of CO_(2) to CH 4 is an effective means of producing value-added fuels,common pho-tocatalysts have poor activity and low selectivity in photocatalytic CO_(2)-reduction processes.Even though creating defects is an effective photocatalyst fabrication route to improve photocatalytic activity,there are some challenges with the facile photocatalyst synthesis method.In this work,an O element is in-troduced into a graphitic carbon nitride(CN)skeleton through a precursory ultraviolet light irradiation pretreatment to increase the visible light absorption and enhance the carrier density of this modified non-metal CN photocatalyst;the charge transfer dynamics thereof are also studied through electrochem-ical tests,photoluminescence spectroscopy,and nanosecond transient absorption.We verify that the op-timized sample exhibits lower charge recombination and a suppressed 84 ns electron-trapping lifetime,compared to the 103 ns electron-trapping lifetime of the CN counterpart,and thereby contributes to ro-bust detrapping and a fast transfer of active electrons.Through density functional theory calculations,we find that the improved light absorption and increased electron density are ascribed to O-element doping,which enhances the CO_(2) adsorption energy and improves the CO_(2)-to-CH 4 photoreduction activity;it be-comes 17 times higher than that of the bare CN,and the selectivity is 3.8 times higher than that of CN.Moreover,the optimized sample demonstrates excellent cyclic stability in a 24-hour cycle test. | Xiaolong Zhao Xiaoping Yi Wending Pan Yifei Wang Shijing Luo Yingguang Zhang Ruijie Xie Dennis Y.C.Leung | 2023 | Journal of Materials Science & Technology2023，，2： | 1 |
| 3 | Aluminum-air battery with cotton substrate:Controlling the discharge capacity by electrolyte pre-deposition显示文摘Conventional Al-air battery has many disadvantages for miniwatt applications,such as the complex water management,bulky electrolyte storage and potential leakage hazard.Moreover,the self-corrosion of Al anode continues even when the electrolyte flow is stopped,leading to great Al waste.To tackle these issues,an innovative cotton-based aluminum-air battery is developed in this study.Instead of flowing alkaline solution,cotton substrate pre-deposited with solid alkaline is used,together with a small water reservoir to continuously wet the cotton and dissolve the alkaline in-situ.In this manner,the battery can be mechanically recharged by replacing the cotton substrate and refilling the water reservoir,while the thick aluminum anode can be reused for tens of times until complete consumption.The cotton substrate shows excellent ability for the storage and transportation of alkaline electrolyte,leading to a high peak power density of 73 mW cm^(-2) and a high specific energy of 930 mW h g^(-1).Moreover,the battery discharge capacity is found to be linear to the loading of pre-deposited alkaline,so that it can be precisely controlled according to the mission profile to avoid Al waste.Finally,a two-cell battery pack with common water reservoir is developed,which can provide a voltage of 2.7 V and a power output of 223.8 mW.With further scaling-up and stacking,this cotton-based Al-air battery system with low cost and high energy density is very promising for recharging miniwatt electronics in the outdoor environment. | Wending Pan Yifei Wang Holly Y.H.Kwok Dennis Y.C.Leung | 2023 | Green Energy & Environment2023，8，3： | 0 |
| 4 | Solid-state Al-air battery with an ethanol gel electrolyte显示文摘Hydrogel electrolyte is especially suitable for solid-state Al-air batteries targeted for various portable applications, which may, however, lead to continuous Al corrosion during battery standby. To tackle this issue, an ethanol gel electrolyte is developed for Al-air battery for the first time in this work, by using KOH as solute and polyethylene oxide as gelling agent. The ethanol gel is found to effectively inhibit Al corrosion compared with the water gel counterpart, leading to stable Al storage. When assembled into an Al-air battery, the ethanol gel electrolyte achieves a much improved discharge lifetime and specific capacity, which are 5.3 and 4.1 times of the water gel electrolyte at 0.1 mA cm^(-2), respectively.By studying the gel properties, it is found that a lower ethanol purity can improve the battery power output, but at the price of decreased discharge efficiency. On the contrary, a higher polymer concentration will decrease the power output, but can bring extra benefit to the discharge efficiency. As for the gel thickness, a moderate value of 1 mm is preferred to balance the power output and energy efficiency. Finally, to cater the increasing market of flexible electronics, a flexible Al-air battery is developed by impregnating the ethanol gel into a paper substrate, which can function normally even under serious deformation or damage. | Yifei Wang Wending Pan Kee Wah Leong Shijing Luo Xiaolong Zhao Dennis Y.C.Leung | 2023 | Green Energy & Environment2023，8，4： | 0 |
| 5 | Paper-based aqueous Al ion battery with water-in-salt electrolyte显示文摘Low-cost,flexible and safe battery technology is the key to the widespread usage of wearable electronics,among which the aqueous Al ion battery with water-in-salt electrolyte is a promising candidate.In this work,a flexible aqueous Al ion battery is developed using cellulose paper as substrate.The water-in-salt electrolyte is stored inside the paper,while the electrodes are either printed or attached on the paper surface,leading to a lightweight and thin-film battery prototype.Currently,this battery can tolerate a charge and discharge rate as high as 4 A g^(-1) without losing its storage capacity.The charge voltage is around 2.2 V,while the discharge plateau of 1.6–1.8 V is among the highest in reported aqueous Al ion batteries,together with a high discharge specific capacity of~140 mAh g^(-1).However,due to the water electrolysis side reaction,the faradaic efficiency can only reach 85%with a cycle life of 250 due to the dry out of electrolyte.Benefited from using flexible materials and aqueous electrolyte,this paper-based Al ion battery can tolerate various deformations such as bending,rolling and even puncturing without losing its performance.When two single cells are connected in series,the battery pack can provide a charge voltage of 4.3 V and a discharge plateau as high as 3–3.6 V,which are very close to commercial Li ion batteries.Such a cheap,flexible and safe battery technology may be widely applied in low-cost and large-quantity applications,such as RFID tags,smart packages and wearable biosensors in the future. | Yifei Wang Wending Pan Kee Wah Leong Yingguang Zhang Xiaolong Zhao Shijing Luo Dennis Y.C.Leung | 2023 | Green Energy & Environment2023，8，5： | 0 |
| 6 | Advances in Researches of Extraction Processes of Total Saponins of Pnanx Notoginseng显示文摘Traditional extraction methods of total saponins of Panax notoginseng include cold soaking method,water decoction method,alcohol reflux method,percolation method,macroporous resin adsorption method,and accelerated solvent extraction( ASE) method. Modern extraction methods include ultrasonic extraction,microwave assisted extraction,supercritical CO_2 extraction,microbial fermentation assisted extraction,neural network model optimized extraction method,and multi-stage countercurrent extraction method. This paper discussed principles of these methods and compared their advantages and disadvantages. | Huaneng PAN Suoyi HUANG Qiaorong YU Wende LU Mengyao LIN | 2017 | Medicinal Plant2017，8，1： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员