|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Design and synthesis of Al-MOF/PPSU mixed matrix membrane with pollution resistance显示文摘To enhance the performance of the polyphenylene sulfone(PPSU) membrane,a novel mixed matrix membrane with hydrophilicity and antifouling properties was prepared.Using PPSU as the ba sic membrane material,polyvinyl pyrrolidone(PVP) as the porogen,N-Methyl pyrrolidone(NMP) as the solvent,and MOF-CAU-1(Al_(4)(OH)_(2)(OCH_(3))_4(H_2 N-BDC)_(3)·xH_(2) O) as the filler,PPSU/CAU-1 mixed matrix membrane(MMM) was prepared by an immersion precipitation and phase transformation technique.By changing the amount of MOF-CAU-1,the properties and performance of the MMM membrane were investigated in terms of hydrophilicity,pore morphology,surface roughness,and dye removal.The results show that the highest pure water flux of the mixed reached 47.9 L·m^(-2)·h^(-1), when the CAU-1 addition amount was 1.0 wt%, which was 23% higher than that of the pure PPSU membrane.Both the rejection rate and the antifouling performance of the MMM membrane also noticeably improved. | Shujuan Xiao Xiaowen Huo Shuxin Fan Kui Zhao Shouwu Yu Xiaoyao Tan | 2021 | Chinese Journal of Chemical Engineering2021，34，1： | 5 |
| 2 | Preparation and properties of PPSU/GO mixed matrix membrane显示文摘Polyphenylene sulfone/graphene oxide(PPSU/GO) mixed matrix membranes with different GO contents are prepared by phase inversion technique using, PEG-1000 as porogen, and N,N-dimethylacetamide(DMAC) as solvent.The hydrophilicity and pure water flux of the membrane are investigated. The morphology, hydrophilicity, thermodynamic stability and compatibility of the membranes are characterized by various techniques such as SEM,TGA, FTIR and so on. The permeation properties of the membrane are measured in terms of pure water flux and bovine serum albumin(BSA) retention. The results indicate that when the GO content is 1.5 wt%, an evenly distributed finger structure has been formed in the mixed matrix membranes. Owing to the presence of GO,the hydrophilicity and the thermal stability of the membranes are improved, and the fouling resistance is also enhanced. | Shujuan Xiao Shouwu Yu Li Yan Ying Liu Xiaoyao Tan | 2017 | Chinese Journal of Chemical Engineering2017，25，4： | 4 |
| 3 | Synthesis and characterization of SrCe_(0.95)Y_(0.05)O_(3-δ) nano powders by low temperature combustion显示文摘Nanosized SrCe_(0.95 )Y_(0.05 )O_( 有同类的作文的 3- δ) 粉末被低温度燃烧过程基于 Pechini 方法综合。聚合先锋大音阶的第五音被把柠檬酸和乙二醇用作我的 chelating 代理人形成以牙还牙的惩罚法。perovskite 类型 SrCe_(0.95 )Y_(0.05 )O_( 有制服的 3- δ) 粉末塑造并且比在尺寸的 25nm 小在硝酸和氢氧化铵的存在通过聚合先锋大音阶的第五音的燃烧被获得。它被发现硝酸和氢氧化铵的数量能控制的那 modulating 残余碳酸盐离子的粒子尺寸,和数量被柠檬酸和乙二醇的数量也影响。 | MENG Bo TAN Xiaoyao ZHANG Baoyan YANG Naitao | 2006 | Rare Metals2006，25，1： | 2 |
| 4 | Preparation of microtubular solid oxide fuel cells based on highly asymmetric structured electrolyte hollow fibers显示文摘A simple and cost-effective method has been developed for the fabrication of microtubular solid oxide fuel cells (MT-SOFCs). Highly asymmetric electrolyte hollow fibers composed of a thin dense skin layer and a thick porous substrate are first prepared by a modified phase inversion/sintering technique. The porous substrate is then formed into the anode by deposition of a Ni catalyst via an electroless plating method inside the pores while the thin dense skin layer serves directly as the electrolyte film of the fuel cells. A porous cathode layer is produced on the outer surface of the Ni-deposited hollow fibers by slurry coating and subsequent sintering to form a complete micro tubular fuel cell. The process has been employed to fabricate yttrium stabilized zirconia (YSZ) supported Ni-YSZ-YSZ-La0.6Sr0.4Co0.2Fe0.8O3-(LSCF) microtubular fuel cells. The maximum output of the resulting cells is 159.6 mW cm-2 at 800 °C when using H2 as the fuel feed and air as the oxidant. | LIU Yang LIU Nan TAN XiaoYao | 2011 | Science China Chemistry2011，54，5： | 2 |
| 5 | Preparation of electrolyte membranes for micro tubular solid oxide fuel cells显示文摘Yttria-stabilized zirconia (YSZ) micro tubular electrolyte membranes for solid oxide fuel cells (SOFCs) were prepared via the combined wet phase inversion and sintering technique. The as-derived YSZ mi- cro tubes consist of a thin dense skin layer and a thick porous layer that can serve as the electrode of fuel cells. The dense and the porous electrolyte layers have the thickness of 3-5 μm and 70-90 μm, respectively, while the inner surface porosity of the porous layer is higher than 28.1%. The two layers are perfectly integrated together to preclude the crack or flake of electrolyte film from the electrode. The presented method possesses distinct advantages such as technological simplicity, low cost and high reliability, and thus provides a new route for the preparation of micro tubular SOFCs. | TAN XiaoYao YIN WeiNing MENG Bo MENG XiuXia YANG NaiTao MA ZiFeng | 2008 | Science China Chemistry2008，51，9： | 2 |
| 6 | Investigation of novel membrane reactors for removal of dissolved oxygen from water显示文摘 | Li K | 2000 | Chemical Engineering Science2000，55，7： | 1 |
| 7 | Highly asymmetric yttria stabilized zirconia hollow fibre membranes显示文摘 | Weining Yin Bo Meng Xiuxia Meng Xiaoyao Tan | 2008 | Journal of Alloys and Compounds2008，，1： | 1 |
| 8 | Oxyfuel combustion using a catalytic ceramic membrane reactor显示文摘 | Tan Xiaoyao | 2008 | Catalysis Today2008，131，14： | 1 |
| 9 | Oxyfuel combustion using a catalytic ceramic membrane reactor 显示文摘 | Xiaoyao Tan | 2008 | Catalysis Today2008，131，14： | 1 |
| 10 | Synthesis of strontium cerates-based perovskite ceramics via water-soluble complex precursor routes显示文摘 | Liu Shaomin Tan Xiaoyao Li K | 2002 | Ceramics International2002，28，： | 1 |
| 11 | Removal of 1,1,1 -trichloroeth-ane from water using a polyvinylidene fluoride hollow fiber mem-brane module: Vacuum membrane distillation operation显示文摘 | Wu Bing Tan Xiaoyao Li K | 2006 | Sepa-ration and Purification Technology2006，52，： | 1 |
| 12 | Morphology control of the perovskite hollow fibre membranes for oxygen separation using different bore fluids显示文摘 | Tan Xiaoyao Liu Nan Meng Bo | 2011 | J Membr Sci2011，378，： | 1 |
| 13 | Synthesis of strontium cerates-based perovskite ceramics via water-soluble complex precursor routes 显示文摘 | Liu Shaomin Tan Xiaoyao Li K | 2002 | Ceramics International2002，28，： | 1 |
| 14 | Preparation and characterization of inorganic hollow fiber membranes显示文摘 | Tan Xiaoyao Liu Shaomin Li K | 2001 | J Membr Sci2001，188，： | 1 |
| 15 | Synthesis of strontium cerates-based perovskite ceramics via water-soluble complex precursor routes显示文摘 | Liu Shaomin Tan Xiaoyao Li K | 2002 | Ceramics International2002，28，： | 1 |
| 16 | Inorganic hollow fibre membranes in catalytic processing显示文摘 | Tan Xiaoyao Li K | 2011 | Curr Opin Chem Eng2011，1，： | 1 |
| 17 | Development of membrane-UV reactor for dissolved oxygen removal from water 显示文摘 | K Li Xiaoyao Tan | 2001 | Chemical Engineering Science2001，56，17： | 1 |
| 18 | Morphology control of the perovskite hollow fiber membranes for oxygen separation using different bore fluids显示文摘 | Tan Xiaoyao Liu Nan Meng Bo | 2011 | J Membr Sci2011，378，12： | 1 |
| 19 | Preparation of LSCF ceramic hollow fiber membranes for oxygen production by a phase-inversion/sintering technique显示文摘 | Tan Xiaoyao Liu Y T Li K | 2009 | Ind Eng Chem Res2009，44，1： | 1 |
| 20 | Solvent distillation by ceramic hollow fibre membrane contactors显示文摘 | Sirichai Koonaphapdeelert Xiaoyao Tan Zhentao Wu | 2008 | Journal of Membrane Science2008，314，12： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员