|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Thermodynamic Assessment and Experimental Investigation of Fe-Al-C System显示文摘Phase diagram information of the Fe-C,Fe-Al and Al-C systems are reviewed and the Fe-Al-C system is assessed.A FeAlC database is created by combining a set of thermodynamic parameters established by Kumar and SSOL database in Thermo-Calc software package.Ternary phase diagrams are calculated with FeAlC and the newly developed Thermo-Calc databases SSOL2 and SSOL4.The FeAIC database is the best one to describe the Fe-Al-C system.A1 and A3 values on the vertical section containing 1.5 wt pct Al are calculated with the FeAlC database in this work.To validate the thermodynamic calculation,critical temperatures A_(C_1) and A_(C_3) are determined by using dilatometer analysis.There exist some errors between the calculated values and the experimental results.So further optimization of the Fe-Al-C system regarding bcc and fcc phases is necessary.The experimental data in this work could be of some value in further optimization. | Weiyan LU Lin LI Li WANG Yanlin HE Shuigen HUANG | 2008 | Journal of Materials Science & Technology2008，24，5： | 3 |
| 2 | Computer simulation of W-C-Co-V system diffusion couples显示文摘Diffusion couples,WC/Co-1at.%C,V8C7/Co,and WC/Co-0.3wt.%V8C7 were constructed and annealed at tem-peratures ranging from 1100 to 1300°C. The concentration profile of V and W atoms in these couples were measured by EPMA. Aided by Thermo-calc & DICTRA software package,the concentration profiles of W and V in established diffu-sion couples were calculated by the moving boundary model according to revised dynamic parameters and MOB database,respectively. Then the concentration profile of W in Co binder during sintering WC-Co cemented carbide was simulated by the Cell model. It can provide reference for composition and sintering process design of cemented carbides with high per-formance. Meanwhile,the validity of revised dynamic parameters of the W-C-Co-V system is verified by the comparison of experimental and simulated results. | HE Yanlin LI Lin HUANG Shuigen Jef Vleugels Omer Van der Biest | 2007 | Rare Metals2007，26，5： | 2 |
| 3 | Modeling of Nucleation and Growth of M_(23)C_6 Carbide in Multi-component Fe-based Alloy显示文摘Three-dimensional atom probe (3DAP) technique has been used to study the nucleation and growth of M23C6 carbide in a supersaturated multi-component Fe-based alloy aged at 800°C. 3D images indicate that the radius of M23C6 carbide after ageing for 10 min is about 9 nm. Concentration profiles of alloy elements in the carbide are also obtained. Combined with PANDAT and Thermo-Calc software, attempts to model the early stages of precipitation are present. The calculated particle size and composition of M23C6 carbide is in good agreement with 3DAP data. | Naqiong Zhu Yanlin He Wenqing Liu Lin Li Shuigen Huang Jef Vleugels Omer Van der Biest | 2011 | Journal of Materials Science & Technology2011，27，8： | 1 |
| 4 | Computer Simulation of Fe-Al-Si System Diffusion Couples显示文摘Diffusion couples, Fe-6.8 wt% Al-1.0 wt% Si/Fe and Fe-6.3 wt% Al-0.9 wt% Si/Fe were constructed and separately annealed at 1050°C for 3 h and at 1000°C for 64 h. The concentration profiles of Fe, Al and Si atoms in these couples were measured by electron probe micro-analysis (EPMA), while the diffusion behavior was also simulated by coupling thermodynamic and kinetic properties of Fe-Al-Si system. The simulation results were in good agreement with the measured concentration profiles showing the validity of dynamic parameters of Fe-Al-Si system. Calculation was made for Fe-7 wt% Al-1 wt% Si/Fe diffusion couples at 1000?C with different diffusion time. Silicon uphill was found under the influence of aluminum. | Zhongping He Yanlin He YiGao Lin Li Shuigen Huang Omer Van der Blest | 2011 | Journal of Materials Science & Technology2011，27，8： | 1 |
| 5 | A 400MHz Single-Chip CMOS Transceiver for Long Range High Definition Video Transmission in UAV Application显示文摘A fully-integrated 400MHz transceiver for high definition video transmission in Unmanned aerial vehicle(UAV)is presented.The transceiver integrates a Receiver(RX),a Transmitter(TX),a tunable multi-mode complex filter,two sigma-delta fractional-N PLL frequency synthesizers and some baseband calibration circuits,which is applicable for both Time division duplex(TDD)and Frequency division duplex(FDD)systems.In order to meet different data rate and sensitivity requirements for control signal and video signal transmission,the transceiver supports BPSK/QPSK/QAM modulation.The receiver sensitivity is–75dBm and the transmitter provides emission power up to 12dBm.Besides,the Error vector magnitude(EVM)of–35dB is measured under 64QAM modulation with 54Mbps data rate.Fabricated in a standard 130nm CMOS process and operated at 1.2V supply for most circuits excluding PA,3.3V supply for PA,the receiver and the transmitter consume 68.2mW and 164.3mW,including the frequency synthesizer,respectively.The total chip area with pads is 6.25 mm^2. | HUANG Shuigen LIN Min WANG Ruoyu CHEN Zhuojun DONG Yemin | 2020 | Chinese Journal of Electronics2020，29，3： | 1 |
| 6 | Diamond dispersed Si3N4 composites obtained by pulsed electric current sintering显示文摘 | Shuigen Huang Akhilesh Kumar Swarnakar Kim Van- meensel Jef Vleugels | 2013 | Journal of the European Ceramic Society2013，33，： | 1 |
| 7 | Recent Application and Progress of Metal Halide Perovskite Photodetector on Flexible Substrates显示文摘In recent years,flexible photodetectors(FPDs)have received increasing attention due to their applications in electronic eyes,flexible sensing,terminal devices,and wearable devices.In addition,metallic halide perovskite materials are considered as future materials for FPDs due to their compatibility with flexible substrates,low cost,simple synthesis methods,and superior optoelectronic properties.This review provides a comprehensive overview of the relevant cutting-edge research in the field of flexible perovskite photodetectors(FPPDs)from 2020 to 2022.First,the evaluation criteria for FPPDs are discussed and the development of perovskite stability criteria is emphatically described.Afterwards,the synthesis methods and device construction processes of metal halide perovskite materials commonly used by researchers in the past three years are described.These include single crystals and low-dimensional materials.Moreover,we have elaborated on the research of self-powered FPPD and its contributions in wearability,terminals,and portability.Finally,a summary of developments and possibilities in the field of FPPDs from 2020 to 2022 is provided. | Shuigen Li Xiangyu Xie Fan Huang Lili Shu Langyu Liu Chasheng Wang Yong Yang Rong Li | 2023 | Chinese Journal of Chemistry2023，41，24： | 0 |
| 8 | Sintering, thermal stability and mechanical properties of ZrO2-WC composites obtained by pulsed electric current sintering显示文摘ZrO2-WC composites 展览可比较的机械性质部分为一些应用作为传统的 WC 公司材料,它提供一个机会给代替 WC 公司。在这研究, 2 mol.% Y2O3 与 40 vol.% WC 稳定了 ZrO2 composites 在 1150 獮愠潭杮映汩 ? 潣灭湯湥獴琠牨畯桧挠慨杲 ? 牴湡晳牥洠 ' 炭鷽?被巩固湩 ?? 映汩 ? 瑡琠敨洠汯' 虥 N 牡氠癥汥. 獥吗?? | Shuigen HUANG Kim VANMEENSEL Omer VAN DER BLEST Jozef VLEUGELS | 2011 | Frontiers of Materials Science2011，5，1： | 0 |
| 9 | Prediction of the Isothermal Sections in the ZrO_(2)- YO_(1.5)-CeO_(2) System显示文摘 | LinLI Shuigen HUANG Luoping XU Omer Van Der Biest Jozef Vleugels | 2001 | Journal of Materials Science & Technology2001，17，5： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员